Product Feature
Applicable to production and development needs: the original power supply can be used, on the basis of which the number of modules can be increased or reduced flexibly to increase or decrease the current, so as to improve the utilization rate of the equipment.
Improve the reliability of production operation: N+1 mode is adopted in power supply design. Under normal conditions, all modules are involved in the work. In case of failure of equipment, the system will automatically reduce current operation and exit fault unit, so as to not influence production.
Convenient maintenance: all module units are generalized, only a few module units need to be backed up to freely replace the fault module. the fault module maintenance is relatively simple.
Digital control: the control core of each module is microprocessor, and the software program is mainly used to realize automatic flow sharing and other control schemes. The control is flexible, high in accuracy fast in dynamic response, using less components and high in reliability.
The whole power supply system adopts intelligent bus structure, realizes hot plug and pull of modules, and displays the fault information of fault detection with uniform flow control. The user interface is intuitive and friendly.
High-frequency switching power supply adopts inverter technology, and its power factor is very high, which can reach above 0.9 without reactive power compensation. The harmonic content is also small. The on-state voltage drop is effectively reduced, the efficiency of the machine is improved and the energy is saved by using the fast recovery tube rectification method. The characteristics of high efficiency and high power factor make it save electricity by 20% compared with ordinary SCR rectifier and 30% compared with silicon rectifier.
Electrical parameter
| Output current | 1000~60000A |
| Output voltage | 0~48V |
| Efficiency | 85%~95% |
| Ambient temperature | -10 ° C ~ +40° C |
| Ambient humidity | ≤ 90% |
| Power factor | 0.9~0.95 |
| Output frequency | 34KHz |
| Output Ripple | 5%（Accept Customization） |
| Current precision | ≤±0.5%(rated value) |
| Voltage precision | ≤±0.5%(rated value) |
| Overload capacity | 110% |
| Local operation | Potentiometer, Touch Screen |
| Remote operatoin | Ethernet/RS485/Analog（Accept Customization） |
| Control mode | Constant Power, Constant Voltage, Constant Current |
| Cooling mode | Water Cooling/Air Cooling |
Frequently Asked Questions (FAQ)
The power supply system allows you to easily increase or decrease the number of module units based on your original power supply configuration. This flexibility helps adjust the output current to match your specific production or development requirements, optimizing overall equipment utilization.
The system utilizes an N+1 redundancy mode. If a single unit fails, the system automatically isolates the faulty module and reduces current operation, ensuring that the rest of the system continues to run without interrupting your production process.
No, maintenance is straightforward. All module units are generalized, which means you only need to keep a few spare units in stock to quickly replace a faulty module without complex repair procedures.
By using high-frequency switching and inverter technology with fast recovery tube rectification, the power supply achieves a high power factor above 0.9. This design saves up to 20% more electricity compared to ordinary SCR rectifiers and 30% compared to traditional silicon rectifiers.
The system supports Constant Power, Constant Voltage, and Constant Current control modes. It can be cooled via Water Cooling or Air Cooling, depending on your setup. Operations can be managed locally via Potentiometer and Touch Screen, or remotely through Ethernet, RS485, and Analog connections.